If MICTOR is the Connector HSI is the Place

Ribbonized, matched impedance MICTOR™ multi-conductor cable assemblies from HSI help stream high-speed data and other signals into dense places, which meet performance demands of modern high-speed servers and networks.

Based on 34 AWG through 38 AWG gauge cables, the ribbonized construction improves skew caused by conductor length differences. The ribbonized cables are available as 50-Ohm flexible cable assemblies (100-Ohm differential pairs) featuring tightly controlled impedance throughout the connectors, cables, and interconnections for high signal integrity (SI) and optimum bit-error-rate (BER) performance. HSI’s MICTOR™ multi-conductor cable assemblies are available in 0.5 mm and 0.8 mm pitch versions, and are designed to combine ease of installation with outstanding electrical performance for today’s high-end servers and networks, telecommunications systems, and high-performance test equipment.

Build your cable today: Mictor Blue Ribbon™ Builder.
 

Features

  • Available in 0.5 mm and 0.8 mm pitch versions
  • 34 AWG to 38 AWG cables
  • Consistent performance with repeated mating/unmating cycles
  • Low-profile assemblies require minimum clearance in tight systems
  • Matched impedance for exceptional signal integrity

     
connector options
MICTOR SB (.5 mm & .8 mm) 40, 60 80, 120, 160, 180, 200,
MICTOR (.035 mm) 38, 76, 114, 152, 190,
Custom PCA with Connector of Your Choice		 Direct to board fine wire attachment to .175 mm
also available.
Performance Ranges
Skew Insertion Loss Propagation Delay
<50 ps -3 dB @ 950 MHz Up to 4.9 nsec/m
Rate Time Cross-Talk Conductor Capability
<200 ps -20 dB @ 1 GHz
(Far-end, Differentially Driven)		 .22 Amps (DCR -<20 Ω/m)
Cable Configurations
Coax 34, 38 AWG, 50 Ω